You can often hear about steel cord conveyor belts, so what are the operating specifications for steel cord conveyor belts in daily work? Let’s take everyone to take a look!

The staff must receive induction training before they start to work. They must be concentrated during the operation. They are not allowed to leave the operation post without authorization. Sleeping, or talking or playing with other people is strictly prohibited. The guardian must check the equipment according to the inspection route. The driver should use the signal to contact the guardian at the nose, tail and transfer points for confirmation. If you do not switch on when you receive an unknown signal or have doubts about the signal, you must re-contact the guardian at the head, tail, and transfer points of the machine, and then start the machine after receiving the confirmation signal.

When starting each shift, the belt should be idling for a cycle first, check the conveyor components, conveyor belt surface and joints, instruments, and operating parameters. After confirming that it is normal, run with load. When the signal disappears during operation or an unknown signal suddenly appears, the machine should be shut down immediately, contact the guardian at each point, and then start the operation after confirming that it is correct. When the machine is shut down due to a power outage, the electrical equipment should be placed in the power outage position to be locked and tagged, stick to the post, and report to the dispatching room in time. Except for equipment and system failures, heavy-load shutdowns are strictly prohibited.

When handling the conveyor belt deviation, it is strictly prohibited to directly touch the conveyor belt and the rotating parts of the equipment with your hands, feet and other parts of the body. The driver's class should carry out patrol inspections according to the prescribed route, and if any problems are found, they should be dealt with in a timely manner, and they should be reported to the staff on duty in the district team and recorded. Operators who overhaul and deal with faults should lock the nearby lock switch without error before they can work. After the overhaul is completed, the operator will cooperate to test various protections and send a start-up signal to notify the driver after the sensitivity is confirmed to be ready to start the conveyor.

The above are the operating specifications for the use of steel cord conveyor belts. I hope the above content can be helpful to everyone!